Difference between revisions of "Template:OfficialUbuntuCore/zh"

From FriendlyARM WiKi
Jump to: navigation, search
(Work with FriendlyCore)
(Setup Network Configurations)
Line 16: Line 16:
 
vi /etc/network/interfaces.d/eth0
 
vi /etc/network/interfaces.d/eth0
 
</syntaxhighlight>
 
</syntaxhighlight>
比如修改成静态IP地址,如下所示:
+
For example if you want to assign a static IP to it you can run the following commands:
 
<syntaxhighlight lang="bash">
 
<syntaxhighlight lang="bash">
 
auto eth0
 
auto eth0
Line 24: Line 24:
 
     gateway 192.168.1.1
 
     gateway 192.168.1.1
 
</syntaxhighlight>
 
</syntaxhighlight>
要配置另一个网口 eth1,可以在 /etc/network/interfaces.d/ 下新增一个 eth1 文件,配置格式可以参考 eth0。
+
To change the setting of "eth1" you can add a new file similar to eth0's configuration file under the /etc/network/interfaces.d/ directory.

Revision as of 06:04, 7 February 2020

1 Work with FriendlyCore

1.1 FriendlyCore User Account

  • Non-root User:
   User Name: pi
   Password: pi
  • Root:
   User Name: Root
   Password: fa

1.2 Update Software Packages

$ sudo apt-get update

1.3 Setup Network Configurations

By default "eth0" is assigned an IP address obtained via dhcp. If you want to change the setting you need to change the following file:

vi /etc/network/interfaces.d/eth0

For example if you want to assign a static IP to it you can run the following commands:

auto eth0
iface eth0 inet static
    address 192.168.1.231
    netmask 255.255.255.0
    gateway 192.168.1.1

To change the setting of "eth1" you can add a new file similar to eth0's configuration file under the /etc/network/interfaces.d/ directory.