Difference between revisions of "Template:BurnLinuxToSD-Allwinner/zh"

From FriendlyARM WiKi
Jump to: navigation, search
(烧写Linux系统)
(Install Linux)
Line 6: Line 6:
 
{{#switch: {{{2}}}
 
{{#switch: {{{2}}}
 
| h3 =  
 
| h3 =  
这里以{{#replace:{{lc:{{{1}}}}}|category:|}}_sd_friendlycore-xenial_4.14_armhf_YYYYMMDD.img为例,其他系统的烧写操作是类似的,烧写时的界面如下:<br>
+
Take {{#replace:{{lc:{{{1}}}}}|category:|}}_sd_friendlycore-xenial_4.14_armhf_YYYYMMDD.img as an example here is the installation window. Other image files are installed on the similar window:<br>
 
[[File:win32disk-h3.jpg|frameless|600px|win32disk-h3]]<br>
 
[[File:win32disk-h3.jpg|frameless|600px|win32disk-h3]]<br>
 
| h5 =  
 
| h5 =  
这里以{{#replace:{{lc:{{{1}}}}}|category:|}}_sd_friendlycore-xenial_4.14_arm64_YYYYMMDD.img为例,其他Linux系统的烧写操作是类似的,烧写时的界面如下:<br>
+
Take {{#replace:{{lc:{{{1}}}}}|category:|}}_sd_friendlycore-xenial_4.14_arm64_YYYYMMDD.img as an example here is the installation window. Other image files are installed on the similar window:<br>
 
[[File:win32disk-h5.jpg|frameless|600px|win32disk-h5]]<br>
 
[[File:win32disk-h5.jpg|frameless|600px|win32disk-h5]]<br>
 
}}
 
}}
  
成功烧写后,会看到如下界面:<br>
+
After it is installed you will see the following window:<br>
 
[[File:win32disk-finish.jpg|frameless|600px|win32disk-finish]]<br>
 
[[File:win32disk-finish.jpg|frameless|600px|win32disk-finish]]<br>
  
*当制作完成TF卡后,拔出TF卡插入 BOOT 卡槽,上电启动(注意,这里需要5V/2A的供电),你可以看到STAT灯闪烁,这时你已经成功启动系统。
+
* Insert this card into your board's BOOT slot and power on (with a 5V/2A power source). If the PWR LED is on and the STAT LED is blinking this indicates your board has successfully booted.

Revision as of 03:42, 7 February 2020

1 Install Linux

1.1 Flash to TF Card
  • FriendlyCore / FriendlyWrt are both based on Linux distributions and their installation methods are the same.
  • Extract the Linux image and win32diskimager.rar files. Insert a TF card(at least 8G) into a Windows PC and run the win32diskimager utility as administrator. On the utility's main window select your TF card's drive, the wanted image file and click on "write" to start flashing the TF card.


After it is installed you will see the following window:
win32disk-finish

  • Insert this card into your board's BOOT slot and power on (with a 5V/2A power source). If the PWR LED is on and the STAT LED is blinking this indicates your board has successfully booted.